/******************** (C) COPYRIGHT 2010 ANALOG DEVICES INC ********************
* File Name          : readme.txt
* Author             : Wilfrido Sierra; DAU SW GROUP
* Date First Issued  : 09/20/2010
* Description        : Description of the I2C ADAU1761_DEMO.
********************************************************************************
* History:
* 09/20/2010: V0.1
********************************************************************************
* THE PRESENT SOFTWARE WHICH IS FOR GUIDANCE ONLY AIMS AT PROVIDING CUSTOMERS
* WITH CODING INFORMATION REGARDING THEIR PRODUCTS IN ORDER FOR THEM TO SAVE TIME.
* AS A RESULT, ANALOG DEVICES INC, SHALL NOT BE HELD LIABLE FOR ANY DIRECT,
* INDIRECT OR CONSEQUENTIAL DAMAGES WITH RESPECT TO ANY CLAIMS ARISING FROM THE
* CONTENT OF SUCH SOFTWARE AND/OR THE USE MADE BY CUSTOMERS OF THE CODING
* INFORMATION CONTAINED HEREIN IN CONNECTION WITH THEIR PRODUCTS.
*******************************************************************************/

Example description
===================
This example provides a description of how to transfer a data from SigmaStudio Exported files
into the ADAU1761 DSP.
The communication is a configured on 7bit addressing mode with a clock speed set 
to 100KHz.
The event and buffer interrupts are enabled for I2C1 peripherals. The 
I2C1_Buffer_Tx transfer start when the master I2C1 send a start condition. An 
interrupt is generated on each event or buffer Tx empty or Rx not empty. 



Directory contents
==================
stm32f10x_conf.h  Library Configuration file
stm32f10x_it.c    Interrupt handlers
stm32f10x_it.h    Interrupt handlers header file
main.c            Main program


Hardware environment
====================
 - Connect I2C1 SCL pin (PB.06) to I2C2 SCL pin (PB.10)
 - Connect I2C1 SDA pin (PB.07) to I2C2 SDA pin	(PB.11)
 - Check that a pull-up resistor is connected on one I2C SDA pin
 - Check that a pull-up resistor is connected on one I2C SCL pin


How to use it
=============
In order to make the program work, you must do the following :
- Create a project and setup all your toolchain's start-up files
- Compile the directory content files and required Library files :
  + stm32f10x_lib.c
  + stm32f10x_i2c.c
  + stm32f10x_rcc.c
  + stm32f10x_nvic.c
  + stm32f10x_gpio.c
  + stm32f10x_flash.c
    
- Link all compiled files and load your image into either RAM or FLASH
- Run the example


******************* (C) COPYRIGHT 2007 STMicroelectronics *****END OF FILE******