EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (2 topics).
2 topics · 7 messages
Filtered by: #lm63dimax ✕
-
Possibilities for mixing SPI and I2C devices on the same Master Control Port?
I am currently designing the schematic for a DSP Board including the ADAU1452, CAT25512XE EEPROM, LM63DIMAX temp sensor, AK5574 ADC and AK4458 DAC. I am wondering if it is possible to mix SPI and I2C
-
Master control port registers for address width and value?
Is it possible to set the SPI address width using the DSP control registers? I'm asking about the 2-byte (16-bit) versus 3-byte (24-bit) address variations. On a similar note, is it possible to set th