I get the following error message when I link-compile-download. "System.componentmodel.win32exception (0x80004005): The system cannot find the file specified at system.diagnostics.process.startwithcreaterprocess(processstartinfostartinfo) at system.di

Hello skadar,

Can you give us some more info?

Which version of SigmaStudio are you running?

What operating system?

Can you attach a project?

Do other projects properly compile? Projects that previously compiled OK?

Dave T

Dave,

Attached is a dspproj file.

I have these same issues with any of my current dsp project files.

I am running: win10 64 bit, SigmaStudio 4.1, HP Zbook workstation. Ethernet connection to HW (Simon-Kaloi rPod) audio playback and show control unit. Also a serial connection to unit's console port which lets me monitor and give some cpu commands.

Unit has four AD1953 codecs of which I am using 3

What I am encountering is:

1, error message noted previously when I "link-compile-download" followed by "file could not be read" message

2, stepping through the three error messages (apparently one per codec) yields following serial output on console port:

Halt request, verifing completion...

100:0x04 0x00

Halt request, verifing completion...

100:0x04 0x00

Halt request, verifing completion...

100:0x04 0x00

Halt request, verifing completion...

3, Still bar at bottom of screen shows green as if a good connection, says 100%, and "active downloaded"

4, In SigmaStudio Screen controls affect the output but not as desired. for example IC1 input 1 (ch 0), output 1 and 2 make a mono channel (left) with a single input, four band parametric EQ and 3500Hz 12dB/oct crossover

4a, enabling/disabling Gen filter2 affects gen filter3, likewise Gen filter3 affects Gen filter2. I can hear the change in frequency response as I switch.

4b, moving control on parametric disables output filters

4c, disabling/enabling input highpass filter also disables output filters.

5, IC2 (right channel) IC2 input2 (ch 1) outputs3 and 4 behaves similarly

6, IC3 (sums left and right channels for woofer output) uses input 3 outputs 5 and 6 and behaves similarly

7, Audio will not play through any output until a control is moved

8, I have returned the unit to the manufacturer and they say it works correctly on their SigmaStudio installation

9, this why I suspect the installation on my pc

10, Although, I Installed SS with disabled antivirus and firewall as Administrator and run it as administrator..

Hello,

I am contacting you directly.

Look for an email to the address in your profile.

Dave T