How to generate EEPROM image for selfboot at ADAU1452

Hello Takepiro,

Follow the instructions in the user guide for Self-Boot. It is on page 17 of UG-636.

This will write an image into the EEPROM on the evaluation board. However, since you have an EEPROM in the design it will also create a file.

Look at the folder where the project is located. After you compile it will create two folders. One for IC1 and one for IC2. Usually IC2 is the EERPOM so look in that folder and you will find the hex file.

Dave T

Dear Dave-san,

Thank you very much!!

I can get it.

Best regards,

Takepiro