Gilnei

SigmaDSP & SigmaStudio Gilnei Mar 14, 2019 00:00 1 replies Original on forum ↗

Gilnei Question

Mar 14, 2019 00:00

Hello
I am in doubt, where to connect the 4 wires of the USB in the board with the ADAU 1701 the 5v and the ground or neutral ok, but the other two.
Can you help me?
graciously

Gilnei

Report

KJBob Reply

Mar 18, 2019 00:00

Hello Gilnei,

The ADAU1701 boots from its I2C interface. Besides power and ground, typically three wires are used: SDA, SCL, and ~Reset.

The chip has no built-in USB interface, so typically an adapter such as the EVAL-ADUSB2EBZ. is used. Searching Engineer Zone for "USBi" will provide more information.

Best regards,

Bob

Report