Unable to read SPI LTC6812 data
Subscribe
I have connected TI controller as Master and LTC6812 as slaves on SPI.
Only 4 signals are connected to AFE namely CLK,MISO,MOSI , Data from master.
I can see that MISO,MOSI and CLK are correct but the data begins to receive data but not complete.
How do I check the AFE is working properly with TI
1. Send a wake up pulse on the CS line - Check the voltage on the VREG pin it should be 5V
2. Do a write and read of configuration registers and check if you are able to read from the deivice the same data what you wrote.
- Follow the device protocols as mentioned in the datasheet
Please log in to reply.