Blackfin 60X
hi:
I'm using 609 processors. Adopt CCES development environment. When I am debugging my program step by step, Print information appears below:
1 、 Core fault detected before halt at address: 0xC8000008.
2 、 Target halted due to software breakpoint but no breakpoint found at address: 0xc8000ffc.
I suspect that the processor starts mode wrong after the chip is powered. I would like to ask what kind of startup mode should be set in single step debugging mode?
Hi,
Apologies for the delay. Were you able to get going. In case if you are still facing issue, please provide more information on below points to assist you better on this.
1) Can you please elaborate about your application.
2) Are you using Ez-kit or custom board?
3) Can you please make sure that you are not violating the clock specifications(Page No: 53 / 112) mentioned in the Datasheet.
Can you please refer the below link which talks about "What is the cause of a "Core fault detected before halt at address" error message?"
ez.analog.com/.../faq-what-is-the-cause-of-a-core-fault-detected-before-halt-at-address-error-message
Regards,
Anand Selvaraj.
Please log in to reply.