Urgent ! BF706 Batch burning question.

terryyuan Question

Oct 19, 2020 00:00

Hi guys:

Now,my customer was using BF706 to build a product.

Now it has entered the stage of mass production. At present, the system is booted from flash. Now, multiple devices are required to burn code at the same time. Is there any relevant scheme? At present, it is a direct thimble burning flash mode.

At present, the demand is urgent !

thanks!

Report

Anand Selvaraj Reply

Oct 23, 2020 00:00

Hi,

If you are looking for a solution for Flash Programming in a mass-production environment, 'Danville Signal' has a solution called the 'dspFLASH SHARC and Blackfin Programmer' which is a Production programmer that supports Blackfin processors as well as third and fourth generation SHARC processors. All that is need is a standard ADI JTAG connection on the target. More information can be found on their website at the below location: www.danvillesignal.com/.../dspflash-sharc-blackfin-programmer

Alternative solutions for mass production flash programming are available, for example those from http://www.jtag.com may meet your requirements, or the JTAG Flash Programmer from Ronetix: www.ronetix.at/flash-programmer.html

In addition to Danville Signal Processing, Other volume programming solutions our customers have used in the past include:
>> Data I/O: http://www.dataio.com/
>> BP Microsystems: http://www.bpmmicro.com/

Regards,
Anand Selvaraj.

Report

terryyuan Reply

Oct 26, 2020 00:00

thank you very much! I'm going to try to use it .As long as it can burn LDR files into flash. The operation of CMD is not very friendly to the production line personnel, and the efficiency is a little low .

Report