Difference in Observation
Dear Team ,
I am using the Ext Slew Volume Control .
I have been going haywire with measuring the ramp up and ramp down time when slew mode is set to RC
The ramp up time is different and far off from ramp down time for the same slew rate and input signal .
I understand that manual measurements are prone to personal errors.But a difference of 1-2 ms would have still been understandable. However here the difference is almost 10-20 ms ...How can this be explained ?
Additionally the PDF that you linked me plus the observation table shared by BoB for the slew rate do not match the values I measure .
Is there any formula ? Any procedure ? Any standard ? Or any tolerance range ? ...
Please answer this with figures / charts and detailed solution
Hello Hermione,
We have given you all we have on the subject. There must be an explanation which are most likely in the measurement conditions and details. I would want to see the project you are using to make these measurements and how you are doing the measurements.
You ask about the formulas, I believe we have given that to you in the documentation. we do not measure these since it is programmed into hardware for the hardware slew and software in the software slew modules.
I need to know who you are designing for? Your email in your profile is a gmail account. What is the product and what is the expected yearly production?
Dave T
Please log in to reply.