ADAU1452 Self boot
Dear Mr Dave Thib
Is it possible to use ADAU1452 in selfboot mode (using SPI flash memory) to store the application and continue sending commands to DSP via SPI using a microcontroler?
tks, best regards
fernando
Audio Signal Processors
adau1452
SigmaDSP Audio Processors
ADAU1452 self boot microcontroler
Hi Fernando,
Yes. Please refer to section 'Considerations for Self Boot' in the below wiki page for Interfacing SigmaDSP Processors with a Microcontroller.
wiki.analog.com/.../microcontroller
Hope this will help you.
Regards,
Beaula C
Hello Fernando,
Yes, the slave coms port is always active. Just wait until the selfboot has completed before communicating with the DSP. Reads are OK but do not write until the selfboot is complete.
Beaula gave you a great link for a lot more information.
Dave T
Please log in to reply.