Avoiding -- Error writing user opcode for breakpoint remove -- with SC589 and ICE-1000

MSmithCalgary Question

Nov 12, 2016 00:00

I am developing code for the SC589 and ICE-1000 -- Using Multi-SHARC Audio EE377V2

About 1 time in 3 when I change the code, rebuild the code, and download the code and run code -- CrossCore freezes with this error message -- - Error writing user opcode for breakpoint remove

I have tried resetting the board, unplugging the USB interface, powering down the board and tried to close CrossCore

The only solution is to crash CrossCore -- which then will come back and have to rebuild everything

Anybody found a procedure so that I (and later my students) can avoid crashing CrossCore on download

Thanks

Mike Smith

Audio Signal Processors

error writing user opcode for breakpoint remove

ice-1000

crosscore

adsp-sc589

SHARC Audio Processors/SoCs

Report

ADIApproved Reply

Nov 16, 2016 00:00

Hi,

We understand that you have already contacted our private support. Please continue the discussion there.

To assist you further can you please share us your project which replicates this issue. Also can you please refer the below link:
FAQ: Reporting a Crash or Hang in CrossCore Embedded Studio
https://ez.analog.com/docs/DOC-2388

Regards,
Kader

Report

EZAdministrator Reply

Aug 2, 2018 00:00

This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

Thank you,
EZ Admin

Report