LDR creation error in CCES

sankar6040 Question

Dec 22, 2014 00:00

When i try to build a project in CCES with Artifact Type as Loader file an error message shown as attached.

When i click close the program the build is finished and console window displays as below:

' '

'Building target: SS4SH_EzKit_SDK1_ROMII_CCES.ldr'

'Invoking: CrossCore SHARC Loader'

elfloader.exe -v -proc ADSP-21487 -si-revision 0.3 -bspimaster -fhex -hostwidth 8 -lC:/Analog\ Devices/CrossCore\ Embedded\ Studio\ 1.1.0/SHARC/ldr/489_spi.dxe -o SS4SH_EzKit_SDK1_ROMII_CCES.ldr SS4SH_EzKit_SDK1_ROMII_CCES.dxe

make: *** [SS4SH_EzKit_SDK1_ROMII_CCES.ldr] Error -1073741819

**** Build Finished ****

Audio Signal Processors

adsp-21487

SHARC Audio Processors/SoCs

Report

ADIApproved Reply

Dec 22, 2014 00:00

Hi,

Unfortunately this isn't an error I've seen before. Are you able to share the project? If you prefer not to do so on the EngineerZone, please contact private support through the link below.

http://www.analog.com/support

Does the same build error occur for both the Debug and Release configurations? What about other projects - e.g. if you take one of the example projects and set it to build an LDR file, does the same error occur?

What version of CCES are you using?

Regards,

Craig.

Report

sankar6040 Reply

Dec 23, 2014 00:00

H Craig,

The error occur for both the Debug and Release configurations.

I have tried with example project BubbleSort with same options, no such error occurs.

I am using CrossCore Embedded Studio 1.1.0.

Additionally, I have implemented code and data overlays in my code. Does it need any additional options while creating loader file.

Report

ADIApproved Reply

Jan 5, 2015 00:00

Hi,

As the issue only occurs with your project, it is likely something very specific so we would need to get a reproducible example. As above, if you cannot share that in a public community like the EngineerZone, you can contact private support.

There shouldn't be any additional settings required - the overlay files should be included into the LDR file by the build tools without any additional steps.

Regards,

Craig.

Report

EZAdministrator Reply

Aug 2, 2018 00:00

This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

Thank you,
EZ Admin

Report