Processor selection

Processors & DSP magneto Jul 14, 2011 00:00 2 replies Original on forum ↗

magneto Question

Jul 14, 2011 00:00

I'm currently drafting a design which uses Analog's AD5791 DAC and AD7356 ADC. I was wondering what type of uC/DSP/FPGA to use to actuate these chips. The DAC SDP uses a Blackfin uP but the ADC CED uses a Cyclone FPGA. The controller will initially act as a slave just receiving commands from and sending data to a host computer, but in the future the controller may be requested to perform some of the signal processing. Any suggestions as to which one to pick and why would be greatly appreciated.

Single-Channel Voltage Output D/A Converters

Simultaneous Sampling A/D Converters

ad7356

Voltage Output D/A Converters

ad5791

Precision A/D Converters

Report

jeyanthi.jegadeesan Reply

Jul 29, 2011 00:00

Hi,

I apologize for the delay in getting back on this. Please provide me with more details about your application. And also provide me with more details in terms of the processing needed. I can suggest the processors accordingly.

Best Regards,

Jeyanthi

Report

EZAdministrator Reply

Aug 2, 2018 00:00

This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

Thank you,
EZ Admin

Report