Could not change E2PROM Properties
Hello,
I have ADAU1701 and ADAU1452, in one design.
When I try to edit IC2 properties it always show IC4 properties.
My changes could not be applied.
Audio Signal Processors
adau1452
software
4.7
SigmaDSP Audio Processors
adau1701
Show More
Hello VladYer,
I couldn't replicate your problem.
Are you trying to say that the changes that you had made in IC2, fails to update in the window once closed and open the window again?
After updating the IC2 with your required value and when you close and open it again, rather than showing the updated values of IC2, it shows the properties of the IC4?
If it is the problem, then I'm not facing any trouble as you.
Could you please explain your issue a little further? So that I can try simulating it and I may come up with a workaround.
Regards,
Harish
Please log in to reply.