i need help with a plan for Adau1467 BBE Sonic Maximizer

Hello Lorenzo4711,

I'm not sure what you exactly wanted to do but if you want to separate the frequency band as LOW, MID, HIGH and do certain processing on each band, then it can be accomplished. A crossover block is used to separate these three frequency bands and you can add your own processing elements like delay, gain etc. This is just an overview and what do you exactly want to simulate?

Since your question seems a bit general, If you can tell us what your exact need is, then we will be able to help you with your application.

Regards,

Harish

no i want a function like this device here i have link

https://www.thomann.de/de/bbe_sonic_maximizer_882i.htm

thank you verry much

Hello Lorenzo4711,

BBE is a protected IP process that we used to have a block to do that under license. We no longer have it that I am aware of. Contact BBE and ask them about it.

Meanwhile, we cannot assist you in reverse engineering the process for obvious reasons.

Most of the blocks probably exist for coming close to replicating it but I do not know the details and if I did I could not reveal them here.

I say again, contact BBE and see if they want to produce a version for the Sigma300/350? I think the old one was only for the 1701 but I could be wrong on that. It was a while back.

Dave T

Ok thanks I just did it

unfortunately the company doesn't answer me either on email or on facebook that's sad

Hello Lorenzo4711,

I agree. This is a good easy cash flow for them.

Dave T

can someone help me no one can be reached at bbe sound inc i don't know where to contact you have already tried 3 emails with no response even facebook no response phone doesn't work either