CrossOver corner Frequency setting
HI:
Is it possible to set the frequency in the following figure?
For corner frequency settings， that is to say, there is no restriction ： LowFrequency < (MidLowFrequency-MidHighFrequency) < HighFrequency 。
Who can confirm that?
Thanks
JackLee
software
Hello JackLee,
There are no restrictions within reason.
Dave T
Dave T：
Thank you very much for your reply!
Based on your reply, I can draw the following conclusions:
1> Low.corner Frequency > MidLowFrequency is valid.
2> High.corner Frequency < MidHighFrequency is valid.
3> For corner frequency setting，there are no restrictions for Low 、 Mid and High unit part.
Thanks
JackLee
Hello JackLee,
The beauty of SigmaStudio is that it is easy to jsut try it yourself. Dial it in and see what happens!
I entered fully overlapping values and yes, you get strange combined responses but it lets you do it. It is three different filters so you can set them up however you like. In this example I even overlapped the HF with the LF!
Dave T
Please log in to reply.