SigmaStudio+ Sample rate propagation

SigmaDSP & SigmaStudio sam@bbinet.com Apr 28, 2026 00:00 2 replies Original on forum ↗

Thread Summary

The user encountered an issue where the T-Connector in SigmaStudio+ did not propagate the sample rate downstream. The solution was to connect one output directly to multiple inputs, bypassing the T-Connector, which resolved the sample rate propagation problem. No need to use Splitters.
AI Generated Content

sam@bbinet.com Question

Apr 28, 2026 00:00

I found out that the T-Connector would not propagate sample rate downstream. Remove the T-Connector and connect straight to the next block and the block's sample rate follows upstream. Does anyone have the same issue? Any suggestion how to fix this other than using Splitters?

Thanks.

software

SigmaStudio+ 3.3.0

Report

sam@bbinet.com Reply

Apr 29, 2026 00:00

Never mind. I have been using SigmaStudio and automatically added T-Connector in SigmaStudio+. But now I realized that I can connect one output to multiple inputs without a T-Connector. My sample rate now propagates properly.

Thanks.

Report

Harishgowtham Reply

Apr 29, 2026 00:00

Hello,

Thanks for taking your time and reporting back.

All the best for your upcoming tasks!

Regards,

Harish

Report