ADAU1467 Can't set SDATA IO
I tried to configure Serial Inputs, Serial Outputs and SDATA IO with EVAL-ADAU1467Z. Serial Inputs, Serial Outputs no problems but when I activate SDATA IO seams not to work. SigmaStudio 3.16 and SigmaStudio 3.17 tried.
I want to divide port 0 in two TDM8 and port 2 in two I2S.
How to make it happen: 2 TBM8 (same clock source) and at the end 6 I2S?
Audio Signal Processors
adau1467
SigmaDSP Audio Processors
ADAU1467 SDATA IO not working : It's a show stopper bug in SigmaStudio 3.16/3.17.
Sentosa,
The bug in SigmaStudio is only in the graphics, and not in the actual configuration of the hardware. You mentioned that you have an evaluation board? Please tell me the exact configuration that you want (which formats on the inputs and which formats on the outputs, including the SDATAIOx pins), and I will create, test, and upload a working project for you.
I apologize for the difficulty that you are having,
Best regards,
Ken
Already wrozte it here:. https://ez.analog.com/message/338132-re-adau1467-sdata-io-not-working?commentID=338132&et=watches.email.thread#comment-3…
Need to have port 0 and port 1 TDM8 or TDB16, port 2 and port 3 each two I2S. Total 2 TDM8 and 4 I2S.
0..7 TDM8 port 0
16..23 TDM8 port 1
32/33 I2S port2 36/37 I2S SDATA IO 0/1
40/41 I2S port 3 44/45 I2S SDATA IO 2/3
All Inputs and outputs.
This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.
Thank you,
EZ Admin
Please log in to reply.