I want to change ways proccesing audiosignal
Subscribe
I'm using processor for car audio based ADAU1701.
I want to create two options for processing of audiosignals and then select between them using a fixbutton
The input audio signals are going through two paths processing: 1. crossover, delay, EQ. 2 crossover and EQ without delay. I want to choose between this ways. How can a do this?
Audio Signal Processors
SigmaDSP Audio Processors
adau1701
Hello navin_ekb,
Here is a project that does what you asked for. You may have to change to other GPIO pins or you might not want the GPIO volume control. You will have to make changes in the register settings if you change any of this. But this project is a good start.
Dave T
Please log in to reply.