Are ADAU1962 & ADAU1978 available in SigmaStudio?

Hi Tang,

Both of these parts have their own control GUI. You need to download from the product page.

For ADAU1962A

http://www.analog.com/en/products/audio-video/audio-codecs/adau1962a.html#product-documentation

For ADAU1978

http://www.analog.com/en/design-center/evaluation-hardware-and-software/evaluation-boards-kits/eval-adusb2ebz.html#eb-relatedsoftware

Thanks

Rajeev

Hello Tang,

For the ADAU1962A, you can use SigmaStudio to control it. You also can use the ARWB program if you like. The SigmaStudio DLL is labeled ADAU1966. This DLL will work for the 1962, 1966A and 1962A. The small differences will not effect the operation of the part. Of course any controls for channels above 12 will not work because it is only a 12 channel DAC. Also, the settings for the common mode voltage cannot be set to 5V for the "A" version of parts that operate only at 3.3V. So the differences are rather obvious and you cannot damage the part by selecting them.

Thanks,

Dave T

Hi Rajeev & Dave,

Thanks very much for your quick response!

Although EVAL-ADUSB2EBZ Applicable part includes ADAU1978, I can't find it in SigmaStudio.

Or it is like ADAU1962 which can be controlled by other product family item in SigmaStudio?

Thanks very much!!

Henry Tang

Hi Tang,

As mentioned in my earlier reply, the ADAU1978 is not supported in sigmastudio library. However there is standalone GUI for the ADAU1977/78/79 parts. The GUI uses the same USBi board. Download the GUI from the link below under Software tab

http://www.analog.com/en/products/audio-video/audio-ad-converters/adau1977.html?doc=EVAL-ADAU1977Z_1978Z_1979Z_UG.600.pdf#product-evaluationkit

Regards

Rajeev

Hi Rajeev,

Understood and thanks very much for your explanation!!

Thanks very much!

Henry Tang