LUT problem in Sigmastudio
On my office computer Windows 10 Enterprise , 64bit , I can load a LUT - interpolator with limits +/-1 .
When I load the project in sigmastudio 3.12 and 3.13beta , no problem.
On my MACBOOK PRO ( parallels Desktop, Windows 10 Enterprise 64bit ) I load the the same project and it gives me an error message.
( sigmastudio 3.12 and 3.13beta )
When I change the +1 input limit to 0,99 or 1.01 it starts with no problem.
( see attached error message and attached project )
What can be the reason ?
Yes it seems to work correct.
But I have projects with lots of LUT's inside and its really time consuming to open the project with these errors.
Hello,
I got the same error using a Dell laptop and Windows 10 home, so apparently it's not limited to the Mac + Parallels environment. Does your overall project work anyway? I tried running the affected LUT with an oscillator and RT Display as shown below, and the LUT operates correctly despite the error upon opening:
Best regards,
Bob
Hello stmoeller60,
Since I have my personal MACBOOK Pro here at my desk at ADI I tried this using Parallels and a Windows 7 virtual system and I got the same error. So it may be an error on several systems.
I will report it to the team and see if there is anything they can do. I have a feeling it will be an operating system issue.
Thanks,
Dave T
Thanks for your replies and attention.
Hello stmoeller,
I was told that this bug will be fixed in the next beta release probably late August 2016.
Thanks,
Dave T
Thats good news !!
Thanks Dave
Hi Dave,
unfortunatly the new 3.14 beta does not start after successfull installation in Windows 10.
Hello,
Have you tried the 3.14 released version that is out now?
Dave T
Please log in to reply.