Problems with SW connection Sigma Studio to EVAL-ADUSB2EBZ
We face a problem with an eval board (EVAL-ADUSB2EBZ) at the moment.
When starting sound setting in Sigma Studio, the data transfer is working, which is shown by the blinking yellow LED. Afterwards there should be a short sound cut, but in this case the sound output is stopped completely We tried severeal setups with SigmaStudio 3.1 & 3.8, but alwasy with the same above named result. But when we usa a 5-6 year old board, everything is working fine
Hello Didi,
Did you try the most current revision of SigmaStudio? 3.12.4?
The 5 or 6 year old board you mean the USBi correct? (We call the EVAL-ADUSB2EBZ the USBi, it is shorter)
What processor are you using?
Is the program really large?
Do you have a large number of meters and readback cells enabled by default in the project? This will cause a lot of communications to happen right away.
Dave T
This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.
Thank you,
EZ Admin
Please log in to reply.