Something dragging FILTD down.
Hello all, finally managed to get my ADAU1701 board sort of up and running and programmed!
The problem is after around 10-20 seconds of being powered up the voltage on FILTD starts to get dragged down, although not straight down, the voltage jumps around. I have a test signal being applied to the on board ADC which is visible on the DACs, the FILTD voltage jumping coincides with the amplitude of the sine wave at the output jumping around. The 1.5v bias point remains but amplitude does not.
Possibly a coincidence but I was able to link compile download once and I wasn't getting this problem, I disconnected the USBi, reconnected, tried again and then was getting comms failure then this problem was happening.
I can't see any other voltages that jump around, everything seems to be as expected. Clock seems stable, though not a perfect sine wave.
Any ideas?
Thanks.
Audio Signal Processors
SigmaDSP Audio Processors
adau1701
Forgot to add, recommended 100nF and 10uF caps were fitted. Also replaced. 100nF cap removed and only 10uF cap fitted to rule out solder damage to the surface mount 100nF as the cause. But no luck.
This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.
Thank you,
EZ Admin
Please log in to reply.