Relevant information isn't visible in ADAU144x hardware configuration screen

Hi Gerard,

Which version are you using? This problem popped up when we updated SigmaStudio for Windows 7, but it has been fixed in more recent versions. I'm using the pre-release version 3.9, which should be publicly released sometime soon, and the problem has been fixed. Here's an example screenshot.

Thanks,

Brett

Hi Brett,

Thank you for the fast answer.

I use sigma studio on two computers with two different operating systems.

The screenshot was from my desk computer which runs under windows 7, the SigmaStudio version on this computer is 3.8.2.1146.

But I have the same problem with the sigmastudio version which runs under Windows XP on my work table, the SigmaStudio version on this computer is 3.7.3.994.

See the attached file.

With kind regards,

Gerard.

Hi Brett & Gerard,

The version 3.8 HW register window displays OK in 1366x768 resolution, but not in 1024x768. I was able to get a usable display at 1024 resolution with this method:

Open your project

Close the toolbox and output windows

Save the project and close SigmaStudio

Restart SigmaStudio and open the project again

Best regards,

Bob

Hi Bob,

Also the suggested screen resolution doesn’t work, I have the impression the screen resolution hasn’t any influence.

With kind regards,

Gerard.

Hi Gerard,

I confirmed that the issue is resolved in version 3.9. I'm not sure about the public release schedule for 3.9, but hopefully it will be out in a few weeks.

Thanks,

Brett

Hi Brett,

Hopefully it will be available when I’am back, over two weeks.

With kind regards,

Gerard.

This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

Thank you,
EZ Admin