I2C addressing problem

Hi There, how are you?

I recently designed my own SigmaDSP board featuring 2x ADAU1701 and a PIC24F. Very well, everything working great, except that I can NOT address the DSPs separately:

DSP 1 has both ADDR0 and ADDR1 tied to the ground, so its address is 0x68. DSP 2 has ADDR0 tied to +3V3 and ADDR1 tied to GND, therefore its address should be 0x6A. Correct?

The thing is, when I send I2C commands to DSP1, using 0x68 physical address, BOTH DSPs respond. If I use 0x6A as address, none of the DSPs respond. Weird thing is that I measured ADDR0 of DSP2 at the PIN and it is indeed tied to +3V3, so it can't be a hardware problem.

Any ideas? It's driving me crazy!

Thanks!!

Audio Signal Processors

SigmaDSP Audio Processors

adau1701