ADAU144x Multiple IC Output Routing

ben@inovon.com Question

Jan 20, 2012 00:00

My question is simular as it is about routing serial ports etc. I am using Sigma Studio with 2 x ADAU1445 chips on a PCB. I have the schematic all done but when I go to look at the Register Control for the two chips, only the information for the Routing Matrix is populated for IC1. When I click on the IC2 tab, none of the Routing Matrix is populated. I know the informaton must be in there somewhere because the hardware (PCB Design) works, but there is no way to change which outputs go where.

Also, is there the entire Sigma Manual in PDF form for download?

Thanks so much.

Ben

Audio Signal Processors

adau1445

SigmaDSP Audio Processors

Report

ADIApproved Reply

Jan 25, 2012 00:00

Hi Ben,

I branched this to a new discussion topic because it is a new idea with a different SigmaDSP.

I just tried to duplicate the issue with a simple project using two ADAU144x ICs. I was able to control the routing for both of the ICs by clicking on their respective IC tabs. So, I can't see the same problem.

Could you please let me know some more details?

Operating system?

SigmaStudio version?

Do you have a screenshot to illustrate the problem?

Report