How to run EVAL1466 in I2C control mode?
Subscribe
Hello
How to run Eval1466 in I2C mode?
When I switch Mport mode to I2C, comunication to ADAU1466 is lost (USBi comm is failed) and I can't change anything on register control manualy (for ex, read ADC, write state of MPxx pin).
Audio Signal Processors
SigmaDSP Audio Processors
adau1466
Traxman,
Unfortunately, the evaluation board is hard-wired to work only in SPI mode. The switch is not properly connect, and was removed in the next revision of the board.
Ken
Please log in to reply.