EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (8 topics).
8 topics · 43 messages
Filtered by: #document ✕
-
ADAU1401/ADAU1701 TCP/IP Documentation ( Unonficial, self made )
Hi Guys, this is my ADAU1701/ADAU1401 TCP Documention PDF Edit Notes Updateing files... [edited by: Rocha at 9:00 PM (GMT 0) on 7 Apr 2020] Audio Signal Processors adau1401 TCP IP Packet Documentation
-
EVAL-ADAU1467Z Documentation mismatch. Documentation available Rev.A, Product received Rev.B
I bought the Evaluation Board. Unfortunately the documentation on the site is of version A, while the Evaluation Board received is in revision B. As shown in the attached image, on the left I took the
-
EVAL - Adau1467 schematics
We've bought an EVAL-ADAU1467Z for the development of a professional audio processor. In the related document UG-1134 schematics I don't find the codec section in particular the schematic of U3 (AD193
-
Documentation error in ADAU1701-c.pdf
Pretty sure this is the wrong place to post this, but I sent to Analog support already, and they sent me here, so..., here goes. (attached, snippet of document page.) ---- I have been attempting to ta
-
Programmatic Control through MatLab Documentation
Hello, I am presently working with the SigmaDSP 1940 development board, and would like to control the DSP through Matlab, to programmatically change the gain or delay, but I cannot figure out the valu
-
Installing SigmaStudio on a networked PC
With some networks, the users' My Documents folder is mapped to a network drive for backup purposes. This is supposed to be transparent to each user, but it may cause your SigmaStudio installation to
-
different from the helping document
Hi! I find a serious proble that the value of coefficient which generate from the SigmaStudio is different from the equation of helping document! For example,a 1st order filter,We set for 1000HZ frequ
-
ADAU144x Possible wrong pin numbering in documentation?
While designing the IC component for the DSP in my CAD software, I found some info in documentation that confuse me. According to last documentation ADAU1442_1445_1446 revision B, on table 27 "Output