EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (6 topics).
6 topics · 15 messages
Filtered by: #sample_5f00_rate ✕
-
ADAU1466Z Sample Rate Conversion
I'm working on a project involving SigmaStudio and EVAL-ADAU1466Z dev kits, and I'm having problems with sample rate conversion. I have the board set to the default sample rate of 48 kHz; what I'd lik
-
How to Implement Single Input Connection with Various Sample Rates
Hi, I have viewed the following thread : https://ez.analog.com/dsp/sigmadsp/f/q-a/64255/adau1467-sample-rate-converter-problem I have also been examining SigmaStudio and the blocks with parameters tha
-
ADAU1452 Eval @ 96 or 192kHz
I'm investigating the use of the ADAU1452 for a 96kHz or 192kHz project, and am wondering if the eval board would be helpful, given the (baffling) restriction that the CODEC is stuck at 48kHz that's b
-
Multi-Rate Project on ADAU1452
Hi there, Is there any way to set up a multi-rate project in Sigma Studio using the new ADAU1452? Thanks for any help getting started. Kind regards, Chris Audio Signal Processors adau1452 multi-rate s
-
Hardware Sample Rate vs Software Sample Rate
I am confused and am looking for more explanation about the difference between the hardware and software sample rates. Do they have to match? Can your hardware rate be higher than your software rate?
-
Big problem when over 50% MIPS
Hi there, at the moment I am working on a fairly complex application where I use ADAU1442. 6 channels analog in (via ADC), 6 channels digital in (via AES/EBU-receiver + ASRC inside ADAU1442) and relat