EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (7 topics).
7 topics · 16 messages
Filtered by: #sigmastudio+4-5 ✕
-
Issues understanding the running average block
Hello thank you for taking your time to read my issue, I am attempting to design a logic flow to distinguish between two signals of the same amplitude (Value = 1.0): A sustained pulse with a duration
-
Runtime Delay Adjustment Causing Unexpected Glitch in SigmaStudio 4.5
I'm using multiple simple Delay blocks to offset separate data flows in a SigmaStudio 4.5 project. ___________________________________________ Example Setup: SourceA --> DelayA --> SourceA_delayed Sou
-
SigmaDSP Standard RMS Compressor Algorithm Reference
Currently using the standard independent RMS module to implement Dynamic Range Compressor/Limiter Now, I will describe the specific situation in detail The transfer function of the current compressor
-
ASRC RAMP MAX Override option in ADAU1466 Processor
Hi Team, I have a query in 'ASRC RAMPMAX OVR' Configuration enabling in ADAU1466 processor-based code. Please support. While 'ASRC RAMPMAX OVR' Configuration is enabled and value set as '-12', around
-
Query regarding Tone burst module
Dear Team, We require the following information regarding Tone burst module available in Sigma Studiov4.5 Toolbox. We have observed that there are two Tone Burst Generators : Sweep Log with (on/off) s
-
ASRC output rate setting for the Serial Output Port.
We need to configure SDATA OUT0 Port as slave. Hence, we need to configure ASRC for this output Port to sync with the external clock. Please confirm the output rate setting for this requirement. 'Use
-
I have ADAU1452 schematic that I need to run on an ADAU1451. Do i really need to redraw the whole schematic?
I developed a fairly large algorithm in SigmaStudio, which runs with about 90% instruction / cycles (just to give some indication of it's size). I've been testing / running the code on the EVAL-ADAU14