sigma studio crossover block options unable to open
I am running into a problem with Sigma Studio where in my schematic, blocks are intermittently unable to be configured. For example I have 3 inputs, 3 crossover blocks, 3 stimulus, a 3 mixers, 2 splitters, 4 probes & 7 outputs. After configuring one of the crossovers and checking the probe for the response and then going back to the configure the crossover, the button on the block will not open the crossover settings?
I have tried to quit Sigma Studio and re open and it still has the problem in the project. It happens in both Design & Active: Downloaded Mode.
Using Windows 10 Home Version 1607 & Sigma Studio 3.14 Build 2 Rev 1690
Attached project...
Any ideas? Thanks
sigmastudio
crossover
Hello,
When you encounter this problem try hitting Ctrl-Shift-F6. This function is called Zoom to Normal in Version 3.14, and Zoom to Selection in Version 3.15. Either way, it resets your project view to 1:1 or 100%.
Blocks will only open when the zoom is exactly 100%. If you have wheel zoom or two-finger trackpad zoom (etc.) on your PC or laptop, it's easy to inadvertently zoom an unnoticeable amount, causing this issue (I've disabled all such features). Also in recent SigmaStudio versions the zoom level is saved with the project, so closing & re-opening no longer helps. Please see: FAQ: Why can't I control any of the knobs or sliders in my SigmaStudio project?
Best regards,
Bob
This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.
Thank you,
EZ Admin
Please log in to reply.