Sigmastudio compile code

We always use some filters in system,Usually several parameters are changed,For example a Medium Size EQ’s Slider (dB),Gain(dB),Q,center frequency etc see figure 1 and 2

Note: I link compile without USBi Eval_board

1:

Nows we use above paramter to link compile and export system files.

Program_Data[XX]= {

0x00, 0x00, 0x00, 0x00, 0x01,

0x00, 0x10, 0x00, 0xE8, 0x01,

0x00, 0x22, 0x03, 0x20, 0x01,

0x00, 0x1A, 0x04, 0x22, 0x01,

0x00, 0x12, 0x00, 0x22, 0x01,

0x00, 0x0A, 0x01, 0x22, 0x01,

0x00, 0x02, 0x02, 0x22, 0x01,

0x00, 0x28, 0x00, 0xE2, 0x01,

0x00, 0x29, 0x08, 0x20, 0x01,

0xFF, 0x68, 0x00, 0x02, 0x01,

…… }

Paramter_Data[XX]= {

0x00 , 0x80 , 0x00 , 0x00 ,

0x00 , 0x00 , 0x00 , 0x00 ,

0x00 , 0x00 , 0x00 , 0x00 ,

0x00 , 0x00 , 0x00 , 0x00 ,

0x00 , 0x00 , 0x00 , 0x00 ,

…… }

I can not find out difference between center frequency 1000Hz and center frequency 10000Hz

2:Q

The result of “link compile and export system files” is same above??????

3: Slide

Program_Data[XX] is same above.

Paramter_Data[XX]= {

0x00 , 0x84 , 0x0A , 0xBF ,

0x0F , 0x0A , 0x3E , 0x39 ,

0x00 , 0x73 , 0xD5 , 0xEA ,

0x00 , 0xF5 , 0xC1 , 0xC7 ,

0x0F , 0x88 , 0x1F , 0x57 ,

…… }

Paramter_Data[XX] is not same above,5-group data are changed all !!!!!

So I do not know how to generate MCU code center frequency 1000Hz and 10000Hz

Audio Signal Processors

code

adau1401

sigmastudio

SigmaDSP Audio Processors

compile

Show More