SigmaStudio Freeze Schematic Bug ?

Can somebody check this please ?!

Hi Barricade,

I was unable to duplicate this behavior. I made a project, exported the system files, and saved the result. I then froze the schematic and exported the system files again. The results were the same, as you can see in this side-by-side comparison of the two outputs.

(Click the image below to view it in its original size)

Actually, this was generated using SigmaStudio 3.9 beta (which is currently installed on my system, but not yet publicly available), so perhaps it is a recent fix. I'll check with the software team to see if that's true.

Hi Barricade,

The software team says no updates were recently made to the Export System Files feature that would cause the functionality to change. Perhaps this is dependent on the actual project file. Are you able to share the project file with us for debugging purposes?

Hi Brett,

after starting the preparing for the project, the exportfiles and the procedure I can not show you

again the difference beetween the export files anymore.

OK. So, is the problem resolved now?

Yes I hope, I changed already the thread as answered.

This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

Thank you,
EZ Admin