Relay With 1701

Does this solution work well, that seems of it?

hi Miguel, I have looked but I have not found anything.

If you know me to say where I find it the thing it is pleasant

Thanks

Miguel, perhaps I will be stupid but I don't understand as I can use Toggle OnOff to build my relays

Thanks Bob,

works very well however he uses a lot of instructions in more than mine.

It has of positive that doesn't attenuate the signal mine him.

I will see which of the 2 to use

Piero

Hi Piero:

I believe there is a Toggle switch built into SigmaStudio for the 1701.

Regards

Miguel

HI Piero,

Toggle OnOff switch is under GPIO conditioning. You will have to use 2 of them to switch between oscilators.

Miguel

Hi piero,

A multiplexer ("mux") can perform your desired function similar to a relay. Please see below:

The mux selects which source appears at its output, according to your control signal at its red pin. This control input must be an integer -- in SigmaDSP, an integer starts at Bit 0, the least significant bit. The easiest way to make an integer from a 5.23 variable is to use the Buffer Gate (as shown above) or Zero Comparator (which also performs a logic negation).

Bob

Thanks Bob,

The solutions are very interesting, you are genial.

Piero

Hi Piero,

The ABCD Comparator block is very handy. You can use it as a mux, and for some reason it uses way fewer instructions than a mux (even the non-slew mux):

If your goal is to select between two sine-wave frequencies, you can do even better with a VCO;

Best regards.

Bob