two USBi boards, 2 targets, one SigmaStudio

Hi brett,

I have need to send a private and urgent email, but trying to send her the answer is always full box.

How can I do?

Thanks

Can you power the boards independently, so that the USBi could be removed from either board without having the board power down? If so, the simple solution would be to power up both boards, and program the individual SigmaDSPs independently.

I guess the steps would be as follows:

1. Power up both boards

2. Plug USBi into board A

3. Load project A in SigmaStudio

4. Link-compile-download

5. Disconnect USBi from board A and plug it into board B

6. Load project A in SigmaStudio

7. Link-compile-download

Of course, Brett, that is what I am doing. Also, both boards have eeproms and can be burned.

I was hoping to avoid the steps of disconnecting the debug connectors so many times.

Thanks.

Understood. Well, I'm not sure if the separate copies of SigmaStudio will be able to differentiate between the two USBis. I've never tried that, but I imagine that the driver doesn't have the support built-in for multiple devices to be used simultaneously.

This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

Thank you,
EZ Admin