Tracking Filter Boost/Cut Resets Itself

Austin Question

Jul 19, 2011 00:00

I'm using the Tracking Filter block in a program and every time I re-launch SigmaStudio, the boost or cut of the filter goes back to zero. I'm positive I'm saving it, and all my other paramaters are fine (Q stays constant, gain is at 0 anyway, other blocks and filters don't have an issue) I can set them and while I'm in the program everything is working correctly, but if I save and exit (either close the project or SigmaStudio entirely) they go back to 0 booost/cut the next time I open the project.

I have two tracking filters in the circuit and both have the same issue, I seem to remember running into this problem before, but I can't be sure, and I don't remember solving it. Any ideas on what my problem might be?

SigmaStudio 3.4 ADAU1701 Windows 7

Thanks.

Audio Signal Processors

tracking

filter

sigmastudio

SigmaDSP Audio Processors

adau1701

Report

ADIApproved Reply

Jul 25, 2011 00:00

Sorry to reply so late. I was in China from July 15th-23rd and I didn't have much time to check the forum.

I will attempt to reproduce this issue and will report it to the software team.

For now, you can use the right-click Cell Settings - Save option to keep the settings saved and avoid the headache of having to manually reset each control when you open the project. When you open the project, then you can use Cell Settings - Open to recall your saved settings.

Alternately, you could do right-click Project Settings - Save to save the settings of all cells in the project.

This is just a workaround ... We will try to solve the root issue ASAP.

5325d60ebcfa724574ffbb5576f68388.jpg-450x220.jpg

Report

Austin Reply

Jul 25, 2011 00:00

No problem on the wait Bret, I hope you enjoyed your time in China.

Thanks for the help. For now I think I'll just stick to setting the filters manually, there are only two so it's not a big hassle, the main issue is remembering to do it. Let me know if there's any other information you need from me on recreating the issue.

-Austin

Report

Austin Reply

Mar 26, 2013 00:00

Is there any update to this? I'm still having the same issue with the newest version of the software.

Thanks.

Report

Jackie Reply

Sep 1, 2016 00:00

I meet same problem in SS 3.13, I come here for answer and I saw this thread. It seems has not been resolved.