Need help with SigmaStudio design using ADAU1701 ADC Inputs

The audio input block can be found in the IO section of the SigmaStudio library. For the ADAU1701, the top four pins are the ADC inputs, and the bottom 8 pins are the digital input channels. The evaluation board documentation (pdf link) has details on setting up a first SigmaStudio project to run on the ADAU1701. See the quickstart section starting on page 3 for more details.

Hi Jerad,

I am working with EVAL-ADAU1701MINIZ until our proto board is ready. I did read through the document before starting to work with SigmaStudio and I guess that I glazed over when I saw “Figure 6. Digital Audio Input 0 through Input 7…” I did not notice the green check marks starting at 2 and going through 9, just the fact that this input type was labeled “Digital”. Thanks for clearing this up.

Ray

From: JeradL analog@sgaur.hosted.jivesoftware.com

Sent: Monday, July 26, 2010 12:55 PM

To: Raymond Donnelly

Subject: New message: "Need help with SigmaStudio design using ADAU1701 ADC Inputs"

<https://ez.analog.com/index.jspa>; Analog Devices EngineerZone

Need help with SigmaStudio design using ADAU1701 ADC Inputs

reply from JeradL <https://ez.analog.com/people/JeradL>; in SigmaDSP Processors - View the full discussion <https://ez.analog.com/message/11982#11982

This question has been assumed as answered either offline via email or with a multi-part answer. This question has now been closed out. If you have an inquiry related to this topic please post a new question in the applicable product forum.

Thank you,
EZ Admin