EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (4 topics).
4 topics · 18 messages
Filtered by: #ak5574 ✕
-
View SECONDARY_I2C traffic in Capture Window?
In another thread, I saw a Capture Window log with IC 1.SECONDARY_I2C Block writes logged. I'm currently seeing I2C transactions on the secondary bus using a Beagle I2C analyzer, but I'm wondering how
-
Not seeing I2C traffic on SCL2_M,SDA2_M pins with ADAU1463
My circuit board has SCL2_M and SDA2_M connected to a DAC, ADC, and two AD2437 chips. This I2C bus has pull-ups on the PCB, immediately beside the ADAU1463 pins, and then the traces continue to the AD
-
Possibilities for mixing SPI and I2C devices on the same Master Control Port?
I am currently designing the schematic for a DSP Board including the ADAU1452, CAT25512XE EEPROM, LM63DIMAX temp sensor, AK5574 ADC and AK4458 DAC. I am wondering if it is possible to mix SPI and I2C
-
Master control port registers for address width and value?
Is it possible to set the SPI address width using the DSP control registers? I'm asking about the 2-byte (16-bit) versus 3-byte (24-bit) address variations. On a similar note, is it possible to set th