EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (4 topics).
4 topics · 17 messages
Filtered by: AD2437 ✕
-
View SECONDARY_I2C traffic in Capture Window?
In another thread, I saw a Capture Window log with IC 1.SECONDARY_I2C Block writes logged. I'm currently seeing I2C transactions on the secondary bus using a Beagle I2C analyzer, but I'm wondering how
-
Not seeing I2C traffic on SCL2_M,SDA2_M pins with ADAU1463
My circuit board has SCL2_M and SDA2_M connected to a DAC, ADC, and two AD2437 chips. This I2C bus has pull-ups on the PCB, immediately beside the ADAU1463 pins, and then the traces continue to the AD
-
How to configure the ADAU1452 signal processing on the EVAL-AD2437A1NZ
Using SigmaStudio+, I connected two EVAL-AD2437A1NZ boards via USBi, configuring one as Main and the other as Sub. The connection is established correctly. The EVAL-AD2437A1NZ Manual states that Sigma
-
Example that consistently hard crashes SS+ 2.2.0 upd 2
Open the attached. Select the Stream Configuration (this seems to be a factor to make it fail), and let it link. Select the System tab Open the 2nd to last sub node (shown selected in above capture) D