EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (4 topics).
4 topics · 16 messages
Filtered by: #dac+output ✕
-
ADAU1701 IIS input 192Khz signal to enable filter, DAC playback has noise
Specific operation description: As shown in the schematic diagram above, currently only one General 2nd filter is added, set to hpf and 60Hz corner frequency. Set the sample rate to 192K and the DSP c
-
Adau1467 expand I/O ADC and DAC
Dear sir/madam, As I am working with the Adau1467, I'm running out of ADC and DAC pins. For this application I would like to use at least 6 microphones, 1 audio input and 14 DAC outputs. I could use t
-
ADAU1787 i2s input to DAC Output with filters
Hello, I want to pass the incoming i2s signal (from a bluetooth to i2s device) to EQ Filter and then as output to the DAC. I used this as an example, but removed the FDEC: ADAU1787 two-way bluetooth s
-
How to select filters using input as the controller?
Hi, I'm working on a project where I need to switch the filters for different magnitude of input using ADAU 1701. Here is what I have so far: Zoom in to the upper part: So I try to use the RMS lookup