EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (3 topics).
3 topics · 14 messages
Filtered by: #i2c+programming ✕
-
Which Registers control SPI Mode and other configuration?
The datasheet warns that "The master port must be reconfigured in software before using a protocol other than the one configured at boot time." So, how is this done? Which Registers control this confi
-
Programming ADAU1761 using Sigma Studio Capture Window Address + Data sent from microprocessor Circuitpython via I2C
I am (usualkly) successfully able to use address and data copied from the capture window of Sigma Studio to program an ADAU1761 via I2C. I use CircuitPython running on an nRF52840-based microprocessor
-
Much noise when connecting an I2C programmer to a ADAU1701 board .... what would be a general reason?
I have just made a new PCB with a ADAU1701, PCM1808 and 2 x PCM5102A I'm using Wondom ICP5 I2C programmer connected to RST, WP, SCL SDA and GND. When I connect the programmer to the board, I get quite