EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (5 topics).
5 topics · 30 messages
Filtered by: #i2c+write ✕
-
Rotary Encounter Write with MCU not working
Hey guys, I am failing in setting the rotary encounter volume externally with an MCU. This is my DSP Program: This is my xxx_IC_1_REG.h file contents: Now when do a I2C read on that Register I get bac
-
Setup a software controlled DAC/ADC through i2c with ADAU1466
Hi everybody, I'll detail the board as much as I can: So, the board have a ADAU1466, 4x PCM5122 and 1x PCM1865, both ADC and DAC are software controlled through i2c, with its respective addresses corr
-
ADAU1452 I2C Master Control Port IO (Startup Boot) continuously sending
Hi, I'm trying to config an external codec via I2C from ADAU1452. I'm using the Startup Boot version of the Master-Control-Port-IO expecting it to only send one time after DSP Boot the XML-code below,
-
Setting up an ADC with an ADAU1463 over I2C
Hi, I'm trying to Settup an ADC through I2C. The ADAU1463 operates at Selfboot Mode, so I have to settup the ADC with the DSP. I've tried to send I2C writes with the "Master Control Port IO" block, bu
-
ADAU1701 (EVAL-ADAU1701MINIZ) i2c write issue
Hello everybody! I am tryng to use a TI MSP430F6638 microcontroller to comunicate via i2c with my EVAL-ADAU1701MINIZ. I set the i2c rate at 400KHz, and I placed two 2k2 resistors connected to 3v3 to p