EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (6 topics).
6 topics · 18 messages
Filtered by: #indirect+parameter+access+table ✕
-
SigmaStudio+ Indirect Parameter Accees Table
In old SigmaStudio you could add a parameter to the IPAT with a simple mouse right-click. Is there a similar feature in SigmaStudio+? I can only add it via the IPAT table but it gets annoying when the
-
Indirect Parameter Access Table
Hi, Having issues with the IPAT. I have enabled the proper options, built a table, did the update, recompiled and then stored to EEPROM. For some reason, I cannot access the IPAT addresses, just the o
-
How to map Indirect Parameter Access parameters to GUI controls?
I am learning about the Indirect Parameter Access and can't locate any documents that correlate the gui controls on schematic components to the parameters listed for indirect access. Some are obvious
-
Indirect Parameter Access Table
Hello, there are some new parametersets in the selection box concerning the params of the moduls: current... and target... (see picture) What do i have to choose to write new values? Marc DSP: Adau 14
-
Hierachy boards and indirect parameter access table
I have a design in SigmaStudio 4.5 using the ADAU1452 with hierachy boards where, for instance I have 4 output channels which have the same processing map. So each channel has an identical Hierachy bo
-
Indirect Parameter Access Table Read/Write to same parameter
Hi, i would like to perform both reading than writing to a parameter but don't know how to. In the wiki is explained that two separate indirect addresses should be used but looks like the image is mis