EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (2 topics).
2 topics · 11 messages
Filtered by: #iovdd ✕
-
Chip damage from IOVDD low while I2C active?
This is a related to an old thread, but I wasn't sure if my response would be seen: https://ez.analog.com/message/106256#106256 I can understand that having IOVDD (3.3V) powered down while SDA/SCL are
-
About the relation between AVDD and IOVDD at ADAU1761
Should I use same voltage for AVDD and IOVDD? [ex) AVDD = IOVDD = 1.8 or 3.3V] If power supply settings are AVDD = 3.3V and IOVDD =1.8V, is it OK? And in this case,is the supply current increase? My c