EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (6 topics).
6 topics · 26 messages
Filtered by: #mips ✕
-
Compiler Error, run out of MIPS
SigmaStudio project that I've been working on suddenly cannot compile, nothing has changed but now it won't compile. This project has been running in it's general form for some time and is not very la
-
Getting close to 100%mips with ADAU1442
Hi, I found the thread "https://ez.analog.com/message/38550#38550" and this say if mips will reach to 99% or more, audioable noise, glich will be heard. Is there a guidline to ensure proper signal pro
-
ADAU1701 Crossover and Switch compiler error
If anyone can be of some help on this. Attached is a stripped down portion of the schematic for a project which implements 2 stereo crossovers. The crossovers are than fed to a Clickless SW Slew MUX t
-
Taming sloppy schematics
As a project grows ad-hoc, it tends toward an unholy mess. It seems the sovereign remedy is to take a deep breath and redraw the project with the same stuff but this time with hindsight, following sta
-
Big problem when over 50% MIPS
Hi there, at the moment I am working on a fairly complex application where I use ADAU1442. 6 channels analog in (via ADC), 6 channels digital in (via AES/EBU-receiver + ASRC inside ADAU1442) and relat
-
Compiling an ADAU144x project with greater than 100% MIPS
I recently received this question from a customer: _____________________________________________ We’ve noticed that Sigma Studio will compile without protesting even though MIPS resources might be gre