EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (4 topics).
4 topics · 14 messages
Filtered by: #sigma+studio+output+file ✕
-
Sigma Studio IC-1 address incorrect
The 1701 literature (page 23, table 16) reports a bunch of device addresses with the address and R/w# combined. This is wrong, as the address is 7 bits not 8. If addr0 and addr1 are tied low, the devi
-
ADAU1452 Filter control/parameters
I'm using a general 2nd order filter (with automaticcalculated coefficients) block on Sigmastudio 3.13. On this block I'm able to select the filter type. Among filter types of interest for my project
-
Sigmastudio 3.11 and 3.12.4 beta export system files bugs
I checked the export system files function with the newest version with the same design. Against my used version 3.8 I see different export bugs: in xxx.params one section is doubled (3.11 and 3.12.4)
-
*_REG.h file output from Sigma Studio appears corrupt?
I am trying to use Sigma Studio to set the registers on a 1761 codec on my custom-designed board. My architecture uses an FPGA/EEPROM pair to store and load register contents - I don't have a processo