EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (5 topics).
5 topics · 17 messages
Filtered by: #timer ✕
-
How can I change the gain with timer in sigma studio?
Hi, I want to change the gain coefficient("Learning Rate") after 5 seconds. Can it be changed by timer? software ADAU1787 Sigma Studio 4.6 timer Integrated/Special Purpose A/D Converters gain ADAU 178
-
Timer in adau 1467
Hi, I want to utilize timer in adau1467. Requirements: If input=1, output=1 (without any delay or hold) If input=0, output=0 (output stays at zero for 30ms no matter whatever input is). Audio Signal P
-
Timer with ADAU1701
I need to make a timer with ADAU1701 that can do this: If an S6 button is pressed and released briefly, nothing has to happen, but if the same button is held down for 2 seconds, I turn on the red MP11
-
Timer w/ External Reset
Hello, I'm trying to set different selectable durations for the "Timer w/ External Reset" (ADAU1701, Sigmastudio 3.1). I'm using 3 DC Input Entries and a Mono Index Selectable Switch. What happens whe
-
How do I start a timer after power-on, or when the input signal goes away?
How do I start a timer when the SigmaDSP powers on, and then output a GPIO flag when the timer is complete? This could be used, for example, in power sequencing for a system that requires staggered st