EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (13 topics).
13 topics · 61 messages
Filtered by: #cces ✕
-
Current Maturity of Custom C/C++ Development on HiFi 3z Core?
Dear Team, We are evaluating the ADAU1797A for a hearable/audio application and need to implement a custom feature extraction algorithm (statistical/spectral analysis of the incoming audio stream) dir
-
SigmaStudio+ Indirect Parameter Accees Table
In old SigmaStudio you could add a parameter to the IPAT with a simple mouse right-click. Is there a similar feature in SigmaStudio+? I can only add it via the IPAT table but it gets annoying when the
-
Indirect Parameter Access Table
Hi, Having issues with the IPAT. I have enabled the proper options, built a table, did the update, recompiled and then stored to EEPROM. For some reason, I cannot access the IPAT addresses, just the o
-
Noise Floor in Digital Domain Spectrum During Sine Wave Playback on ADSP-21568
Dear Team, We tried to verify the example code located at C:\Analog Devices\EV-2156x_EZ-KIT-Rel3.0.0\EV-2156x_EZ-KIT\Examples\drivers\adc\ADAU1372_Talkthrough\EV-SOMCRR-EZLITE\21568\ADAU1372_Talkthrou
-
SigmaStudioPlus issues, Gain and Delay
I am using CCES 3.0.2 and SigmaStudioPlus 2.3.0 with ADSP-SC589-EZ board. I am facing two issues in SigmaStudioPlus 2.3.0. 1) The simple Gain module does not have the NumChannels option, very inconven
-
ss4sh
Translation: Dear ADI technical support: I recently ran into a problem with SS4SH development and was hoping you could give me some answers. I'm using SC594 and ev-somcrr-ezkit for audio development,
-
OpenOCD with ARM on ADSP-SC594 breaks on each interrupt
I am trying to use ICE-2000 with OpenOCD to debug the ARM SW (FreeRTOs-based) running on my ADSP-SC594 but unfortunately the debugger stops each time an interrupt occurs (e.g. the SVC interrupt for ta
-
How to map Indirect Parameter Access parameters to GUI controls?
I am learning about the Indirect Parameter Access and can't locate any documents that correlate the gui controls on schematic components to the parameters listed for indirect access. Some are obvious
-
Indirect Parameter Access Table
Hello, there are some new parametersets in the selection box concerning the params of the moduls: current... and target... (see picture) What do i have to choose to write new values? Marc DSP: Adau 14
-
Hierachy boards and indirect parameter access table
I have a design in SigmaStudio 4.5 using the ADAU1452 with hierachy boards where, for instance I have 4 output channels which have the same processing map. So each channel has an identical Hierachy bo
-
Indirect Parameter Access Table Read/Write to same parameter
Hi, i would like to perform both reading than writing to a parameter but don't know how to. In the wiki is explained that two separate indirect addresses should be used but looks like the image is mis
-
an error has occurred
hello when i want to open the CCES. i find this problem *an error has occurred see log file* cces 2.8
-
no communication from host pc and 21489 board on sigma studio
Hi I just received the ADSP-21489 EZKITLITE and am starting to work on it. When I connect the USBi block to the ADSP-214xx block in hardware configuration, the USB color is always red and it should be