EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (8 topics).
8 topics · 34 messages
Filtered by: #link ✕
-
ADAU1701 and multible i2S inputs
Hello again, I mangaed to get a APM2 from wondom (ADAU1701) up and running with a PCM5102 DAC from aliexpress and a WM8782 ADC from Audiophonics. This is all described in detail here: ADAU1701 as mast
-
Questions about Programming methods to be used with ADAU1467
I have to select the best components for my new Project that is an audio management system for cabin. It is interesting the ADAU1467. I have seen that it is programmable by means of the use of SigmaSt
-
How to use basic Second order filter to implement the Linkwitz-Riley Filter
Hi, I am trying to implement the Linkwitz-Riley Filter, as I refer this website (https://www.rane.com/note160.html#ref) from this section: "Taken to its most general extremes, cascading any order Butt
-
Adding TOSLINK / optical input to 1701 project?
I have an older design using an ADAU1701, and we'd like to upgrade it to include consumer-grade TOSLINK (optical input), but I don't want to add too much cost. From my reading, this gets complicated,
-
Could the Sigma Studio link-compile with visual dsp++?
HI, I need to compile a program based on C language to apply in sigma DSP ADAU1401. However, the Sigma Studio only support graphic program. In the Sigma Studio, there is Link-Compile in "Tools" menu.
-
Why does the blinking led example in AN-951 not work?
I am trying to get some custom hardware up and running and the blinking led example does not work. I can manually toggle the output pins by using the read/write registers tool but I cannot generate th
-
Link blocks of two DSPs in SigmaStudio - ADAU1446
Hello, Is there a possibility to link some blocks (crossover, volume controls, ect...) of two separate DSPs (ADAU1446, different I2C addresses) together in SigmaStudio? I have the following setup for
-
How can I implement a Linkwitz-Riley filter?
I want to use a 4th-order Linkwitz-Riley filter as a crossover in my system, but I don't see it available in the SigmaStudio library. How can I build this? riley linkwitz filters sigmastudio crossover