EngineerZone Forum
Q&A from Analog Devices EngineerZone: SigmaDSP/SigmaStudio and DSP discussions (6 topics).
6 topics · 27 messages
Filtered by: #sigmastudio_2b00_+3-3 ✕
-
SigmaStudio+ Sample rate propagation
I found out that the T-Connector would not propagate sample rate downstream. Remove the T-Connector and connect straight to the next block and the block's sample rate follows upstream. Does anyone hav
-
Not seeing I2C traffic on SCL2_M,SDA2_M pins with ADAU1463
My circuit board has SCL2_M and SDA2_M connected to a DAC, ADC, and two AD2437 chips. This I2C bus has pull-ups on the PCB, immediately beside the ADAU1463 pins, and then the traces continue to the AD
-
Enable second I2C port on ADAU146x chips?
What are all of the settings necessary to enable the second I2C port on the ADAU146x series of SigmaDSP chips? I have designed and fabricated a board based on the ADAU1463. The only device on the SPI_
-
How to view I2C Read data
I am hoping to use SigmaStudio+ to debug the I2C link between an ADAU1463 and DAC chip. I added the I2C Read External Trigger, connected an On/Off button to the trigger input, and connected the output
-
[Bug Report] Sigmastudio+ 3.3 Full screen mode incorrect in some displays.
Currently I use the display of my laptop, plus an external 4K display. When setting Sigma+ in full screen in the 4K display, the right side of the window is cropped (like it was outside the display).
-
[Bug Report] Pulse Generator Issue with Sigmastudio+ 3.3
Hello everyone, A couple of days ago i figured out there is a new version of Sigmastudio+, so I decided to give it a try to take a look to the new features / algorithms. To start I programmed a blinky